23Date, Time and Language SettingsDate, Time and Language SettingsSetting the Date and TimeYou will need to set the date and time on the camcorder before you can start using it. When the internal clock isnot set, or if the settings were lost because the built-in backup battery is depleted, the [Date/Time] screen willappear automatically with the time zone selected when you turn on the camcorder.1 Push the joystick up/down to select the desired time zone and then press SET (press the joystickitself) to move to the next field.• To move between fields you can also push the joystick left/right.• The default time zone is [UTC-05:00] (New York) or [UTC+01:00] (Central Europe), depending on thecountry/region of purchase. Time zones are based on Coordinated Universal Time (UTC).2 Change the rest of the fields in the same way.3 Select [Set] and then press SET to start the clock and close the screen.NOTES• You can display the date/time in mode with the > [¢ % Monitoring Setup] > [CustomDisplay 2] > [Date/Time] setting.• After the initial setup, you can change the time zone, date and time with the > [B ! System Setup]> [Time Zone] and [Date/Time] settings. You can also change the date format and clock format (12 or 24hours) with the > [B ! System Setup] > [Date Format] setting.• When the built-in backup battery is exhausted, the date and time setting may be lost. In such case, rechargethe built-in backup battery (A 216) and set the time zone, date and time again.• Using the optional GP-E2 GPS Receiver, you can have the camcorder adjust settings automatically accordingto the UTC date/time information received from the GPS signal (A 110).Operating modes: