Special Recording Modes1144 Press the REC button again to stop recording.• The clip is recorded at the selected frame rate.• The tally lamps go out and [SLOW STBY] appears at the top of the screen.5 When you have finished recording, turn off the special recording mode.• Repeat steps 1 and 2 selecting [Normal Recording] instead.NOTESNOTES• Slow motion recording cannot be used together with pre-recording.• When slow motion recording is activated, the [PQ] and [HLG] options in the custom picture file ([Gamma] and[Preset]) and their corresponding LUTs will not be available.• The shooting frame rate cannot be changed while recording.• The time code signal will not be output from the SDI terminal, HDMI OUT terminal or TIME CODE terminal.• If the video format or system frequency is changed, slow motion recording will be canceled and the shootingframe rate will be reset to its default value.• About the time code when slow motion recording is activated:- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode.- If the time code running mode was set to [Free Run], the time code running mode will be changedautomatically to [Rec Run] when slow motion recording is activated.- When the special recording mode is turned off, the time code running mode will return to its previous setting.Pre-recordingWhen pre-recording is activated, the camcorder starts recording continuously into a temporary memory (approx.3 seconds) so when you press the REC button, the clip will contain also a few seconds of video and audiorecorded before you pressed the button.1 Select [Recording Mode].> [Æ ! Recording/Media Setup] > [Recording Mode]2 Select [Pre-Recording] and then press SET.• [PRE REC STBY] appears at the top of the screen.3 Press the REC button to begin recording.• The tally lamps illuminate.• [PRE REC STBY] changes to [Ü PRE REC] while recording.4 Press the REC button again to stop recording.• The clip is recorded. The recorded clip will include a few seconds of video and audio recorded before theREC button was pressed.• The tally lamps go out and [PRE REC STBY] appears at the top of the screen.5 When you have finished recording, turn off the special recording mode.• Repeat steps 1 and 2 selecting [Normal Recording] instead.NOTESNOTES• Pre-recording cannot be used together with slow motion recording.• If the video format or system frequency is changed, pre-recording will be canceled.
