Using Metadata108Using MetadataThe camcorder automatically adds metadata to the recorded clips. You can use Canon XF Utility to check andsearch for specific metadata. You can also create and transfer a user memo remotely using the Browser Remoteapplication (A 162, 170).Metadata components1 Only when an optional GP-E2 GPS Receiver is connected to the camcorder. While recording, GPS information is recordedautomatically by the camcorder (A 110).2 GPS information can only be added to clips already recorded.3 Recording data is logged automatically by the camcorder.Setting a User Memo Created with Canon XF UtilityBefore you can add a user memo, you must first install Canon XF Utility (A 151). Next, create the user memoand save it to an SD card. Once you insert the card in the camcorder and select the user memo, it will be addedto clips you record after that.1 Use Canon XF Utility to save a user memo to an SD card.• For details, refer to Managing User Memo Profiles in the Canon XF Utility Instruction Manual.2 Insert the card into the camcorder’s SD card slot 3.3 Select the user memo [Setting].> [3 " Recording/Media Setup] > [Metadata] > [Setting]4 Select [SD Card] and then press SET.5 Select [User Memo].> [3 " Recording/Media Setup] > [Metadata] > [User Memo]6 Select the file name of the desired user memo and then press SET.• The Q icon appears on the right of the screen.• Select [Off] to record clips without a user memo.NOTESNOTES• After you set a user memo, do not remove the SD card while you are recording. If the card is removed, theuser memo will not be added to clips.• You must set the user memo before you start recording for it to be added to the clips. You cannot change the usermemo already added to a clip using the camcorder but you can do so with Canon XF Utility.• When the optional GP-E2 GPS Receiver is connected to the camcorder, the user memo information will not berecorded, even if you have selected a user memo file from the SD card.Metadata Entering content Checking contentCamcorder Canon XF Utility Browser Remote Canon XF UtilityUser memo: clip title, creator, location and description. – Ü Ü ÜGPS information: altitude, latitude and longitude. Ü1 Ü2 Ü ÜRecording data: Shutter speed, gain value, etc. –3 – – ÜUnique Material Identifiers (UMID): country, organizationand user codes based on the SMPTE standard. Ü – – –Operating modes:
