Colors Bars/Audio Reference Signal104Colors Bars/Audio Reference SignalYou can have the camcorder generate color bars and a 1 kHz audio reference signal and output them from theSDI terminal, HDMI OUT terminal and × (headphone) terminal*.* Audio reference signal only.Color BarsThe camcorder offers 3 types of color bars (SMPTE, EBU or ARIB).1 Select [Color Bar Type].> [v ' Camera Setup] > [Color Bar Type]2 Select the type of color bars and then press SET.3 To activate the color bars, select [Color Bars].> [v ' Camera Setup] > [Color Bars]4 Select [On] and then press SET.• The selected color bars appear on the screen and will be recorded when you press the REC button.• Turning off the camcorder or changing the operating mode to mode will deactivate the color bars.NOTESNOTES• You cannot change the type of color bars while recording or when pre-recording is activated.• You cannot turn the color bars on and off while recording.• If you set an assignable button to [Color Bars] (A 117), you can press the button to turn the color bars on/off.Audio Reference SignalThe camcorder can output a 1 kHz audio reference signal with the color bars.1 Select [1 kHz Tone].> [¡ % Audio Setup] > [1 kHz Tone]2 Select the desired level and then press SET.• You can select one of three audio levels (–12 dB, –18 dB, –20 dB) or [Off] to turn off the signal.• The reference signal will be output at the selected level when you display the color bars, and will be recordedwhen you press the REC button.Operating modes:
