Installation/Settings Problems0YSF-06FSeeCommon Problems(P. 541)also.Problems with the Wired LAN Connection(P. 542)Problem with the USB Connection(P. 543)Problem with the Print Server(P. 543)Machine Problem(P. 543)Problems with the Wired LAN ConnectionRemote UI is not displayed.●Are and set to ?Disabling HTTP Communication(P. 291)Disabling Remote UI(P. 292)●Check whether the LAN cable is connected properly and the IP address is set correctly, and then start theRemote UI again.Connecting to a Wired LAN(P. 188)Network Status Print(P. 586)●Are you using a proxy server? If so, add the machine's IP address to the [Exceptions] list (addresses that donot use the proxy server) in the Web browser's proxy settings dialog.●Is the computer communication restricted byfirewalls?Use the operation panel to set to.Restricting Communication by Using Firewalls(P. 267)Address Filter(P. 395)The LNK indicator is Off.Back Side(P. 19)●Use a straight-through Ethernet cable for the wired LAN connection.●Check that the hub or router is turned ON.●Do not connect the cable to the UP-LINK (cascade) port of the hub.●Change the LAN cable.A connection to a network cannot be established.●Is under set to ?Interface Selection(P. 417)●The IP address may not be set correctly. Set the IP address again.Setting IP Addresses(P. 190)●If you are using an IPv4 address, specify thefixedIP address.Setting IPv4 Address(P. 191)You are unsure of the set IP address.●Check by using Network Status Print.Troubleshooting542
