User Maintenance0YSF-05LThe settings about adjustment of the machine including print position correctionfor each paper source and print quality improvement are listed with shortdescriptions. You can specify those settings when the machine is offline. Defaultsettings are marked with a dagger ( ).Asterisks (*)● Settings marked with an asterisk (*) are not displayed depending on other settings and whether the paperfeeder or SD card (all of these being optional) is installed or not in the machine.Adj. Print Position(P. 420)Recovery Printing(P. 421)Initialize Counter(P. 421)Check Paper Size(P. 422)Substitute Size(P. 422)Auto Detect Ppr Type(P. 422)Short Edge Fd. Prty.(P. 423)Special Image Mode(P. 423)Sp. Transfer Mode(P. 424)Clr/B&W Switch Mode(P. 424)Special Density Mode(P. 425)SD Card Maintenance(P. 425)Special Print Mode(P. 426)Special Print Adj. C(P. 430)Adjust Barcode(P. 430)Update Firmware(P. 430)First Calibration(P. 431)Paper Feed Method(P. 432)Show Job List(P. 432)Import/Export Set.(P. 433)Calibration Freq.(P. 434)Notify to Clean(P. 434)Clean. Notif. Timing(P. 434)Toner Check Timing(P. 434)Spec Tnr Chk Timing(P. 435)Adj. Print PositionYou can adjust the print position for each paper source. Adjusting Print Position(P. 582)Offset Y (2-Sided)You can adjust the vertical print position for printing on the first page (front side) in 2-sided printing mode. Theprint position on the second page (back side) follows the settings for the paper source available when theprinting is started.-5.0 to 0.0 to +5.0 (mm)Offset X (2-Sided)You can adjust the horizontal print position for printing on the first page (front side) in 2-sided printing mode.The print position on the second page (back side) follows the settings for the paper source available when theprinting is started.Multi-Purpose Tray-2.25 to 0.00 to +2.25 (mm)Drawer 1 to 4 *-2.25 to 0.00 to +2.25 (mm)Setting Menu List420
