Setting IPv6 Addresses0YSF-036The IPv6 addresses of the machine can be configured via the Remote UI. Beforesetting IPv6 addresses, check the IPv4 address settings ( Setting IPv4Address(P. 191) ). You need to set the correct IPv4 settings to use IPv6 addresses.The machine can use up to seven of the following IPv6 addresses:Type MaximumnumberavailableDescriptionLink-local address 1 An address that is only valid within a subnet or link and cannot be used tocommunicate with devices beyond a router. A link-local address is automatically setwhen the IPv6 function of the machine is enabled.Manual address 1 An address that is entered manually. When using this address, specify the prefixlength and default router address.Stateless address 4 An address that is generated automatically using the MAC address of the machineand the network prefix that is advertised by the router. Stateless addresses arediscarded when the machine is restarted (or turned ON).Stateful address 1 An address obtained from a DHCP server using DHCPv6.1 Start the Remote UI and log on in Management Mode. Starting Remote UI(P. 336)2 Click [Settings/Registration].3 Click [Network] [TCP/IP Settings].Network195
