ConfiguringEthernet Settings0YSF-03EEthernet is a standard for communicating data in a local area network (LAN). You can setthe communication mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/100BASE-TX/1000BASE-T). In general, the machine can be used without changing thedefaults (Ethernet Driver(P. 394)), but you can change these settings to suit yournetwork environment.1Press().2Use/to select , and press.●When a message appears, press.3Select .4Select whether toconfigureEthernet settings automatically or manually.ConfiguringEthernet settings automaticallySelect and press. The machine detects and automatically sets the communication mode and theEthernet type that can be used.ConfiguringEthernet settings manually1Select , and press.2Select the communication mode.●Select Select or Alternately sends and receives communication data. Select when the machine is connected to anetworking device using half duplex.Simultaneously sends and receives communication data. Use this setting for most environments.Network220
