Setting a Wait Time for Connecting to a Network0YSF-03FWhen a network is designed to enjoy redundant connectivity with multiple switching hubs or bridges, it must have amechanism to prevent packets from looping. One effective solution is to define the role of each switch port. However,communication may still be disrupted for several tens of seconds immediately after you change the way that networkdevices are connected, or if you add a new device. If this type of problem occurs, set a wait time for connecting to thenetwork.1 Press ( ).2 Use / to select , and press .● When a message appears, press .3 Select , and press .4 Enter the wait time in seconds, and press .● Use the numeric keys to enter the time.5 Perform a hard reset. Performing a Hard Reset(P. 498)➠ The settings are enabled after the hard reset is performed.LINKSConfiguring Ethernet Settings(P. 220)Network222
