[Network] [TCP/IP Settings] [Edit] in [IPP Print Settings] Select the [Use TLS] check box[OK]7 Perform a hard reset.● Click [Device Control], select [Hard Reset], and then click [Execute].➠ The settings are enabled after the hard reset is performed.Using the operation panel● You can also enable or disable TLS encrypted communication from the setting menu of the operation panel.Remote UI Settings(P. 393)Starting the Remote UI with TLS● If you try to start the Remote UI when TLS is enabled, a security alert may be displayed regarding thesecurity certificate. In this case, check that the correct URL is entered in the address field, and then proceedto display the Remote UI screen. Starting Remote UI(P. 336)LINKSGenerating Key Pairs(P. 320)Using CA-issued Key Pairs and Digital Certificates(P. 329)Configuring IPSec Settings(P. 301)Configuring IEEE 802.1X Authentication(P. 312)Monitoring and Controlling the Machine with SNMP(P. 235)Security300
