e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE June 2004 © TOSHIBA TEC2 - 44Procedure 6* When the automatic adjustment ends abnormally, error message is displayed.Procedure 7* When the automatic adjustment ends abnormally, error message is displayed.Procedure 10Procedure 17* When the “storing is not performed within 2 minutes after pressing the [START] button at themanual adjustment, the “automatic adjustment” starts automatically.Note:Note:The fuser roller temperature control at the adjustment mode is different from that at the normalstate.Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustmentmode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes afterit has become ready state and then start up the adjustment mode again.[0][5][POWER][POWER]OFF/ON(Exit)[Digital key](Code) [START] ( )Automaticadjustment([FAX])(Test copy)*[CANCEL] or [CLEAR][0][5][POWER][POWER]OFF/ON(Exit)[Digital key](Code) [START] ( )Automaticadjustment ([FAX])(Test copy)*[CANCEL] or [CLEAR][CANCEL]( )[ENTER]Stores valuein RAM[0][5][POWER][POWER]OFF/ON(Exit)[Digital key](Code)[Digital key](Sub code)[START] [START][START][SET] or [INTERRUPT](Value unchangeable)( )Valuedisplayed[0][5][POWER][POWER]OFF/ON(Exit)[Digital key](Code) [START] Automaticadjustment[ENTER]or[INTERRUPT]Stores valuein RAM( )[ENTER]or[INTERRUPT]Stores valuein RAM( )([FAX])(Test copy)[UP]or[DOWN](Adjust a value)[CANCEL] or [CLEAR]( )[UP]or[DOWN](Adjust a value)[CANCEL] or [CLEAR])(Manualadjustment
