June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE2 - 52E910 Finisher jam(Bridge unit)Jam at the bridge unit transport sensor-1: Thepaper does not reach the bridge unit transport sen-sor-1 after it has passed the exit sensor.P. 5-35E920 Stop jam at the bridge unit transport sensor-1: Thetrailing edge of the paper does not pass the bridgeunit transport sensor-1 after its leading edge hasreached the sensor.P. 5-35E930 Jam at the bridge unit transport sensor-2: The trail-ing edge of the paper does not reach the bridge unittransport sensor-2 after its leading edge hasreached the bridge unit transport sensor-1.P. 5-35E940 Stop jam at the bridge unit transport sensor-2: Thetrailing edge of the paper does not reach the bridgeunit transport sensor-2 after its leading edge hasreached the bridge unit transport sensor-2.P. 5-35E950 Job separator jam Jam not reaching the job separator transport sen-sor: The paper has passed through the exit sensordoes not reach the job separator transport sensor.P. 5-11E951 Stop jam at the job separator transport sensor: Thetrailing edge of the paper does not pass the job sep-arator transport sensor.P. 5-11E960 Offset tray jam Jam not reaching the offset tray transport sensor:The paper has passed through the exit sensor doesnot reach the offset tray transport sensor.P. 5-11E961 Stop jam at the offset tray transport sensor: Thetrailing edge of the paper does not pass the offsettray transport sensor.P. 5-11E9F0 Finisher jam(Puncher unit)Punching jam: Punching is not performed properly.[MJ-1025 (When MJ-6005 is installed)]P. 5-36EA10 Finisher jam(Finisher unit)Paper transport delay jam: The paper which haspassed the bridge unit does not reach the inlet sen-sor. [MJ-1022/1025]P. 5-37EA20 Paper transport stop jam: The paper does not passthrough the inlet sensor. [MJ-1022/1025]P. 5-38EA30 Power-ON jam: Paper exists at the inlet sensorwhen power is turned ON. [MJ-1022/1025]P. 5-39EA40 Door open jam: The finisher has been releasedfrom the equipment during printing. [MJ-1022/1025]P. 5-40EA50 Stapling jam: Stapling is not performed properly.[MJ-1022/1025]P. 5-41EA60 Early arrival jam: The inlet sensor detects the paperearlier than a specified timing. [MJ-1022]P. 5-42EA70 Stack delivery jam: It cannot deliver the stack ofpaper on the intermediary process tray to the stacktray. [MJ-1022/1025]P. 5-43EAB0 Finisher jam(Saddle Stitcher sec-tion)Saddle paper transport stop jam: The paper whichpassed through the inlet sensor does not reach orpass through the folding position sensor. [MJ-1025]P. 5-45EAC0 Saddle transport delay jam: The paper which hasreached the inlet sensor does not pass through thissensor. [MJ-1025]P. 5-45EAD0 Other paper jam Print end command time-out jam: The printing hasnot finished normally because of the communica-tion error between the SYS board and LGC boardat the end of printing.P. 5-46Error code Classification Contents Troubleshooting
