e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE June 2004 © TOSHIBA TEC2 - 28[FAX] button: ON ([FAX] LED: ON)Digitalkey Button Items to checkContentsHighlighteddisplaye.g.Normal dis-playe.g.[1]A - - -B - - -C 24 V power supply Power ON Power OFFD IPC board connection Not connected ConnectedE - - -F Polygonal motor rotation status (Motor is rotating at OutputMode (03))Abnormal rota-tionNormal rota-tionG Auger lock switch Lock UnlockH Toner cartridge installation switch OFF ON[2]A Registration sensor Paper present No paperB Exit sensor Paper present No paperC Auto-toner sensor connection Not connected ConnectedD Front cover opening/closing switch Cover opened Cover closedE - - -F Side cover opening/closing sensor Cover opened Cover closedG Transfer cover opening/closing switch Cover opened Cover closedH Main motor rotation status (Motor is rotating at OutputMode (03))Abnormal rota-tionNormal rota-tion[3]A - - -B Key copy counter connection Not connected ConnectedC Job Separator upper stack sensor(When Job Separator is installed)Paper full Paper not fullOffset Tray separate sensor (When Offset Tray is installed) Separator athome positionOther thanhome positionD Fuser unit connection Fuser unitinstalledFuser unit notinstalledE Bridge unit transport sensor-2 (When bridge unit isinstalled)No paper Paper presentF Bridge unit cover opening/closing detection switch(When Bridge unit is installed)Cover opened Cover closedJob Separator cover switch (When Job Separator isinstalled)Cover opened Cover closedOffset Tray cover switch (When Offset Tray is installed) Cover opened Cover closedG Bridge unit paper full detection sensor(When bridge unit is installed)Paper not full Paper fullJob Separator lower stack sensor(When Job Separator is installed)Paper full Paper not fullOffset Tray stack sensor (When Offset Tray is installed) Paper full Paper not fullH Bridge unit transport sensor-1 (When bridge unit isinstalled)No paper Paper presentJob Separator feed sensor (When Job Separator isinstalled)Paper present No paperOffset Tray feed sensor (When Offset Tray is installed) Paper present No paper[4]A - - -B - - -C - - -D - - -E - - -F Bypass feed sensor No paper Paper presentG - - -H High-voltage power supply abnormality (shutdown) detec-tionNormal Abnormal05/11
