Toshiba e-studio200l Service Manual

Also see for e-STUDIO200L: User guide Operator's guide Service manual Service handbook Service handbook

Contents

e-STUDIO200L/202L/230/232/280/282 PREVENTIVE MAINTENANCE (PM) June 2004 © TOSHIBA TEC4 - 24* j1. Separation fingers for fuser rollerThe paper jam may be caused if the tip of the finger is damaged or deformed. If there isany problem with it, replace the finger with a new one regardless of the number of outputpages which have been made. Do not damage the tip of the finger during the cleaning.The finger may be damaged if the toner adhering to the tip of it is scraped off forcibly.Replace the finger if the toner is sticking to it heavily.* j2. ThermistorClean the thermistor with alcohol if the toner or dirt is sticking to it when the fuser roller isreplaced.Do not deform or damage the thermistor during the cleaning. Replace the thermistor with anew one if it is damaged or deformed regardless of degree.* o1. Idling rollerApply one-rice-grain-amount of white grease (Molykote X5-6020) to each part A in the fig-ure below.Fig. 4-19* p1. OCT separator rollerApply one-rice-grain-amount of FLOIL (GE-334C) to the part A in the figure below. Alsoapply three-rice-grain-amount of white grease (Molykote X5-6020) to each part B.Fig. 4-20ABBA