June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING6 - 156*When the updating of the NIC firmware is failed, an error message is displayed as the figurebelow. Turn OFF the power and then check the above-mentioned items. After confirmingthem, select only “4. NIC Firmware Update” and restart updating from the beginning. Thismay complete the updating properly.Fig.6-16If the updating of the NIC firmware is still failed, check the prescription corresponding to the errormessage. After confirming and clearing the problem, restart updating from the beginning.Note:Note:If the updating of the NIC firmware is not completed properly, wait 5 minutes or more from thebeginning of the updating before turning OFF the power, and then restart updating from thebeginning. If you turn OFF the power within 5 minutes, HDD may be destroyed.NIC Error Message Error Contents PrescriptionNIC UPDATE FAILED 1 NIC initialization time-out The IP address may not be assigned cor-rectly.• Is the IP address assigned correctly?• Does the IP address conflict with theother system?If the error still occurs, replace the NICboard because it may be destroyed.NIC UPDATE FAILED 2 ATA driver initialization error The HDD cable may be disconnected.• Is the HDD cable connected correctly?If the HDD cable is connected correctly,replace the SYS board because it may bedestroyed.NIC UPDATE FAILED 3 HDD partition mount error Replace the HDD because it may bedestroyed.NIC UPDATE FAILED 4 NIC setting information backup error Replace the HDD because it may bedestroyed.NIC UPDATE FAILED 5 NIC firmware transfer error Replace the NIC board because it may bedestroyed.NIC UPDATE FAILED 6 NIC firmware writing error Replace the NIC board because it may bedestroyed.NIC UPDATE FAILED 7 NIC status time-out Replace the NIC board because it may bedestroyed.04/09
