Toshiba e-studio200l Service Manual

Also see for e-STUDIO200L: User guide Operator's guide Service manual Service handbook Service handbook

Contents

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING5 - 335[E742] Jam not reaching the reverse sensor (feeding in reverse)Is the reverse roller stained?# YES Clean the roller.NOIs the reverse sensor working? (Perform the input check: 03-[FAX]ON/[7]/[F])llllllll#NO 1) Check if the connector of the reverse sensor is disconnected.2) Check if the connector CN4 on the RADF board is disconnected.3) Check if the connector pins are disconnected or the harnesses areopen circuited.4) Check if the conductor pattern on the RADF board is short circuitedor open circuited.5) Replace the reverse sensor.6) Replace the RADF board.YESReplace the RADF board.[E743] Jam not reaching the exit sensor (feeding in reverse)Are the reverse roller and read roller stained?# YES Clean the rollers.NOIs the exit sensor working? (Perform the input check: 03-[FAX]ON/[7]/[E])llllllll#NO 1) Check if the connector of the exit sensor is disconnected.2) Check if the connector CN4 on the RADF board is disconnected.3) Check if the connector pins are disconnected or the harnesses areopen circuited.4) Check if the conductor pattern on the RADF board is short circuitedor open circuited.5) Replace the exit sensor.6) Replace the RADF board.YESReplace the RADF board.