e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING June 2004 © TOSHIBA TEC6 - 82[A] Update procedureImportant:• The file system of USB storage device should be formatted in FAT format. Be careful sincethe devices formatted in FAT32 or NTFS format will not be operated. The file system can beconfirmed on the properties in applications such as Explorer of Windows.• Do not turn OFF the power during the update. The data could be damaged and not to beoperated properly.(1) Connect the USB storage device to the PC and write the model specific folder in which the datafile is stored.• Confirm the model specific folder name and data file name before writing the data(! P.6-80 "6.5 Firmware Updating with USB Storage Device (e-STUDIO202L/232/282)").• The file system of USB storage device should be formatted in FAT format.• Windows 95 and NT do not support USB. Be careful since the data can not be written on thedevices in the PCs with these operating systems.(2) Shut down the equipment.(3) Connect the USB storage device to the USB connector (host) on the SYS board.Fig.6-79Notes:• Do not connect multiple USB storage devices together.• The USB storage device can be connected to either of 2 USB connectors (host).• In case the printer kit (GM-1070 or GM-1080U), printer/scanner kit (GM-2070 or GM-2080U)and scanner upgrade kit (GM-4070 or GM-4080U) are used, the update must be performedafter all the "dongles" are disconnected from the USB connector (host) and only the USB stor-age device is connected.USB storage deviceUSB connector(host)05/11
