June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING5 - 375[ 3 ] Paper jam in finisher section[EA10] Paper transport delay jamMJ-1022Is there any paper remaining on the transport path in the finisher or equipment?# YES Remove the paper.NOIs the connector J10 on the finisher controller PC board disconnected?Is the harness connecting the finisher controller PC board and inlet sensor (S2) open cir-cuited?# YES Connect the connector securely. Replace the harness.NOIs the inlet sensor working normally? (Check the movement of the actuator.)ll#NO 1) Connect the connector of the inlet sensor securely.2) Attach the actuator securely if its shaft is out of place.3) Replace the inlet sensor.YESReplace the finisher controller PC board.MJ-1025Is there any paper remaining on the transport path in the finisher or equipment?# YES Remove the paper.NOIs the connector CN16 (inlet sensor) on the finisher controller PC board disconnected?Is the harness connecting the finisher controller PC board and inlet sensor open-circuited?# YES Connect the connector securely. Replace the harness.NOIs the inlet sensor working normally? (Check the movement of the actuator.)l#NO 1) Attach the actuator securely if its shaft is out of place.2) Replace the sensor.YESReplace the finisher controller PC board.
