VIPedgeThe BasicsVIPedge UG 12/12 TOSHIBA 21On a Call While on a call you can perform the following:SwitchingBetweenHandset andSpeakerphonePress Spkr and place the handset on-hook to switch from handset tospeakerphone mode.Take the handset off-hook to switch from speakerphone to handset mode.Microphone(Mic/Mute)ButtonThis button toggles between Mic and Mute. When Mic button is lit, handsfreecommunication is supported, when Mic is pressed again and light is off, Mute isenabled and mutes both the microphone and the handset.Hold To place a call on hold, press Hold. Your LCD shows the line on hold. The heldLine’s LED flashes green while appearances of the line at other stations flash red.• To return to the held call, press the flashing held Line button.• If you do not return to the held call within a specified time, it rings back to yourtelephone. The call remains camped-on to your station.• If the held party hangs up, the call is released.• See the Call Pickup section to pick up a call on hold from another extension.Exclusive Hold This feature enables you to place a call on hold so that only you can retrieve it.While on a call, press Hold twice. That line’s LED flashes green whileappearances of the line at other stations are steady red (in use).Automatic Hold This features enables you to move from one Line button to another Line buttonwithout pressing Hold.Check with your System Administrator to make sure this setting is turned on. IfAutomatic Hold is not enabled, calls will drop when moving from one line toanother without pressing Hold.While on a call, press another extension button to receive/originate a new call.The accessed line’s LED flashes (in-use). The first call is put on hold and yourextension’s LED flashes.Consultation Hold 1. While on a call, press Cnf/Trn. The call goes on hold.2. Dial another line.3. Transfer the call or return to the held call by pressing its Line button.
