Panasonic WJ-DR200 Operating Instructions Manual

Also see for WJDR200 - DIGITAL VIDEO RECORD: Operating instructions User guide

Panasonic WJ-DR200 Operating Instructions Manual Manual pdf 6 page image

-4-13. Eject holeFor sliding out the disc tray manually (by inserting awire) if it is not ejected automatically when pressingthe OPEN/CLOSE button (35).21. Find button (FIND)Press to directly specify and play back a frame*2.22. Index button (INDEX)Press to search the disc for a recorded frame.23. Alarm Recording button (ALARM REC STAND-BY)Enables/disables alarm recording.24. Reverse Record button ( )Left buttonPress to move the playback operation back onestep to the previous record*1.In the setup operation, moves the cursor to the leftor select a parameter in reverse.25. Reverse Frame button ( )Down buttonPress in paused playback to move the playbackoperation back one step to the previous frame.In the setup operation, moves the cursor down oneline.26. Advance Frame button ( )Up buttonPress in paused playback to advance the playbackoperation one step to the next frame.In the setup operation, moves the cursor up oneline.27. Set button (SET)In frame search, press to apply the entered value.In the setup operation, press to execute a selectionand enter the submenu associated with the selecteditem.28. Advance Record button ( )Right buttonPress to advance the playback operation one stepto the next record.In the setup operation, moves the cursor right orselect a parameter forward.29. Pause button (yPAUSE)Press to temporarily pause playback.Holding down the Pause button and pressing theREC button (31) will place the device into recordingstandby status.30. Reverse Playback button (AA)Press to play back frames in the reverse order theywere recorded in. Holding the button down willspeed up reverse playback, releasing it will restorethe normal speed.0.2s1.0s0.2sAn error has occurred on the disc in use. Thedisc is about to reach the end of its life cycleand should be replaced.• Blinks rapidly twice, followed by a 1-secondinterval.0.2s1.0s0.2sThe unit’s lens or disc needs cleaning. Seepage 46.• Blinks once, followed by a 1-second interval.0.2s1.0sAbnormal temperature rise inside the unit. Turnthe power off and refer servicing to qualified ser-vice personnel.12. ShutterFor loading/unloading the disc. Pressing theOPEN/CLOSE button (35) on the Control Panel withthe Disc Cover open will open the shutter and slideout the tray.8. Disc coverPrevents dust from entering into the disc drive.Press to open.Do not open except to load or unload a disc.9. Ventilation holesAllow air to enter the device to prevent it from over-heating. Make sure not to block these holes.10. Control Panel coverPress to open for access to the control buttons onthe Control Panel.11. Busy indicator (BUSY)Is on (green) when a disc is loaded.Is on (orange) when the disc drive is in operation.It also indicates an error condition in the discrecorder by blinking in green as follows:• Blinks rapidly three times, followed by a 1-sec-ond interval.<<<