Panasonic WJ-DR200 Operating Instructions Manual

Also see for WJDR200 - DIGITAL VIDEO RECORD: Operating instructions User guide

Panasonic WJ-DR200 Operating Instructions Manual Manual pdf 35 page image

-33-SET_UP PASSWORDA B C D E F G H I J K L MN O P Q R S T U V W X Y Z1 2 3 4 5 6 7 8 9 0CLEAR ENTER(SET)6. Move the cursor to ENTER in the table, then pressthe SET button.“OK” or “NG” is displayed in the lower center of themonitor screen.OK: Correct password, access to setup menu per-mitted.NG: Wrong password, access to setup menudenied. Enter correct password.7. If the password is correct, the display will return tothe previous MAIN menu. Changing/Deleting a PasswordFollow the procedure below to change or delete a pass-word.1. Perform password verification, then display the edit-ing table for the password to be changed or delet-ed.For example, to change or delete the SetupPassword, display the SETUP PASSWORD table.The current password is displayed in the center atthe end of the table.SET_UP PASSWORDA B C D E F G H I J K L MN O P Q R S T U V W X Y Z1 2 3 4 5 6 7 8 9 0CLEAR1231 (SET)2. Move the cursor on the desired character in thetable by pressing the , , or button.3. Then press the SET button to pick up the character,and place it in the password area.4. Repeat the above procedures 2 and 3 until the newpassword is completed.5. To delete characters in the password area, movethe cursor to CLEAR in the table by pressing theor button, then press the SET button.6. Press the SET UP/ESC button for about 2 secondsto apply the setting and exit the setup menu.DISC PASSWORDA B C D E F G H I J K L MN O P Q R S T U V W X Y Z1 2 3 4 5 6 7 8 9 0CLEAR(SET)3. Compose the Disc Password as described for theSetup Password above.4. Press the SET UP/ESC button for about 2 secondsto apply the setting and exit the setup menu. Password VerificationFollow the procedures below to verify a password.For example, to verify a Setup Password:1. Confirm that the parameter PASSWORD is selectedin the MAIN menu, then press the SET button. TheSET UP PASSWORD table shown below appears onthe monitor screen.2. Move the cursor on the desired character in thetable by pressing the , , or button.3. Press the SET button to pick up the character, andplace it it in the password area.4. Repeat the above procedures 2 and 3 until thepassword is completed.5. If a wrong character is selected, press the (+) or (–)button to move the cursor in the password area.Then press the SET button to overwrite the charac-ter selected in the table.Note: Press the (+) button to move the cursor to theright, or press the (–) button to move the cursorto the left.