Panasonic WJ-DR200 Operating Instructions Manual

Also see for WJDR200 - DIGITAL VIDEO RECORD: Operating instructions User guide

Panasonic WJ-DR200 Operating Instructions Manual Manual pdf 29 page image

-27-1. Move the cursor to the PROGRAM TIMER parameterin the ALARM RECORD menu by pressing theor button.2. Select either ON or OFF by pressing the orbutton.ON : Enables Program Timer recording.To program the timer, you need to make thenecessary settings in the associated sub-menu. Refer to the Program Timer menushown below for details.OFF: Disables Program Timer recording.Note: ON mode is available only when the AUTOSTART parameter in the Time Lapse RecordingMenu is set to OFF.The default setting is OFF. Program Timer MenuThis menu lets you select either of two Program Timerrecording patterns for each day of the week.1. Move the cursor to the PROGRAM TIMER parameterin the ALARM RECORD menu by pressing theor button.2. Select ON by pressing the or button, thenpress the SET button. The PROGRAM TIMER menushown below appears on the monitor screen.PROGRAM TIMERSun PROGl *Mon PROGl *Tue PROGl * PROGl START ENDWed PROGl * MODE1 08:00-20:00Thu PROGl * MODE2 20:00-08:00Fri PROGl *Sat PROGl * PROG2 START ENDMODE1 00:00-24:00MODE2 --:-----:--1. Move the cursor to the TIMER DURATION parame-ter in the ALARM RECORD menu by pressing theor button.2. Select an alarm duration between 1 second and 5minutes as shown below by pressing the orbutton.1 sec - 30 sec, 1 min, 2 min, 3 min, 4 min, 5 minThe default setting is 2 sec. Alarm Buzzer SetupThis item lets you enable or disable the buzzer sound inresponse to alarm input.1. Move the cursor to the BUZZER parameter in theALARM RECORD menu by pressing the orbutton.2. Select ON or OFF by pressing the or button.ON: Buzzer enabled.OFF: Buzzer disabled.The default setting is OFF. Alarm Label SetupRefer to Label Setup on page 30 for details. Sensor Label SetupRefer to Label Setup on page 30 for details. Delay Time SetupThis item lets you select the delay between input of thealarm or sensor signal and the start of recording.1. Move the cursor to the DELAY TIME parameter inthe ALARM RECORD menu by pressing the orbutton.2. Select the desired time as shown below by pressingthe or button.OFF, 0.05 sec, 0.10 sec, 0.30 sec, 0.50 sec, 1 sec,2 sec ····· 10 secThe default setting is 0.05 sec. Program Timer SetupThis item lets you enable or disable the Program Timerfunction.3. Move the cursor to the desired day by pressing theor button, then select OFF or PROG 1 or 2by pressing the or button.PROG1: Selects the recording pattern stored inPROG1.PROG2: Selects the recording pattern stored inPROG2.OFF: Disables Program Timer recording.