99EnglishSymptoms Check[Controller ID function] function cannot be used.(When using ID remote controller)Check whether [Controller ID function] is set to [On], or MODE> switch is set to . (see page 66)(When [Controller ID function] is set to [On], you need to set switch to and set the ID number.)The top or bottom of the picture on the screen iscut off.The image position has been adjusted in the [Position]menu.Adjust the position of the picture on the screen.(see page 37, 38)There are areas at the top and bottom of thescreen where picture is not displayed.When using a video software program (such as a cinemasize program) with a screen wider than one in the 16:9mode, blank areas separate from the images are formed atthe top and bottom of the screen.Parts of the unit become hot.Even when the temperature of parts of the front, top andrear panels has risen, these temperature rises will not poseany problems in terms of performance or quality.There is no picture displayed or sound outputsometimes.When HDMI or DVI signals are input to the Display using aselector or distributor, sound or images may not be output inthe normal fashion depending on the selector or distributorused.The symptoms may be improved by turning the power offand on again, or by replacing the selector or distributor.The RS-232C is uncontrollable.Check that the connection has been made properly.(see page 21)To control RS-232C with the Display’s SERIAL IN terminal:Check that [Network settings] - [Serial control] is set to[SERIAL IN].To control RS-232C with the twisted pair cable transmitter:Check that [Network settings] - [Serial control] is setto [DIGITAL LINK], [Network control] is set to [On] and[DIGITAL LINK mode] is set to [Auto], [DIGITAL LINK] or[Long reach].(see page 54, 56)The LAN is uncontrollable.Check that the connection has been made properly.(see page 70)To control with WEB browser control or command control,check that [Network control] is set to [On].(see page 54)Check that [LAN setup] is set properly.(see page 55)When connecting to a device of AMX, Extron or CrestronElectronics, Inc., set [AMX D. D.], [Extron XTP] or [CrestronConnected™] according to the device to use.(see page 57)See the [DIGITAL LINK status] - [Signal quality] informationto check the LAN cable status such as whether the LANcable is disconnected or the cable is not shielded.(see page 56)There is no picture displayed or sound output fromthe [DIGITAL LINK] terminal.Check whether the connection has been made properlybetween the video (output) equipment and twisted pair cabletransmitter and between the twisted pair cable transmitterand this product.(see page 71)Check that [DIGITAL LINK mode] is not set to [Ethernet].(see page 56)
