English60Options AdjustmentsThis unit offers special functions conveniently usedaccording to the installation location and application.1 Press .[Setup] menu screen will be displayed.2 Select [OSD language] withand press for more than 3seconds.Following screen will be displayed.OptionsDisplay serial numberUSB data cloningSoftware licensesShipping3 Select [Options] with and press.[Options] menu screen will be displayed.1/300OptionsInput searchFailover/FailbackAudio input selectOnscreen displayInitial VOL levelInitial inputMaximum VOL levelInput lockButton lockController user levelPC auto settingOffOffOffOnOffOffOffOff2/30---OptionsOff-timer functionInitial startupStartup logoDisplay IDController ID functionSerial ID functionInformation timingLAN control protocol Protocol 1OffOffEnableLast memoryOffSerial response(ID all) OffSerial daisy chain position3/3OptionsPower on screen delayClock displayPower on message(No activity power off)Power on message(Power management)POWER button lock OffOnOnOffOffNote● [POWER button lock] function is only for TH-55SF1HU, TH-49SF1HU and TH-42SF1HU.4 Select the item to set with .For [Input search], [Failover/Failback], [Audio inputselect] and [Information timing], the submenu screenwill be displayed when you press .(see page 60, 61, 64, 67)5 Set with .6 Press to exit from [Options]menu.Note● The remote control is necessary to display the[Options] menu. The control panel buttons on themain unit cannot be used to display the menu.● Press to return to the previous menu.● The serial number of this device is displayed when[Display serial number] is selected in step 3.● The software License is displayed when [Softwarelicenses] is selected in step 3.Input searchWhen a signal is not detected, another input with asignal is automatically selected.Select the item with .Select the set point with .Input searchInput search1st search input2nd search inputCustom(None)(None)[Input search][Off]:When there is no signal, the input is not switchedautomatically.[All inputs]:Searches all inputs and switches to an input with asignal.Input search is executed in the following order.(Example) When the current input is [HDMI1][HDMI2] → [DIGITAL LINK] → · · · · · · · · · →[USB] → [HDMI1]Note● The inputs set to [(Skip)] in [Input label] (seepage 50) are skipped when searching.● When Y/G/VIDEO terminal is used as VIDEOinput, set [COMPONENT]* to [(Skip)].*: [COMPONENT] may be displayed as [RGB]depending on the settings of [Component/RGB-inselect]. (see page 46)
