Panasonic TH-55SF1HU Operating Instructions Manual

Also see for TH-42SF1HU: Operating instructions

Contents

Panasonic TH-55SF1HU Operating Instructions Manual Manual pdf 31 page image

31EnglishSelecting the input signalSelect the signals input to the unit.Press or .INPUTMENUENTERUnitSwitches input every time the buttons are pressed.PC16:9[HDMI1] → [HDMI2] → [DIGITAL LINK] → [DVI-D] →[PC] → [COMPONENT]* → [VIDEO] → [USB][HDMI1]:HDMI 1 terminal, HDMI input[HDMI2]:HDMI 2 terminal, HDMI input[DIGITAL LINK]:DIGITAL LINK / LAN terminal, DIGITAL LINK input[DVI-D]:DVI-D IN terminal, DVI-D input[PC]:PC IN terminal, PC input[COMPONENT]*:COMPONENT/RGB IN terminal, Component input[VIDEO]:VIDEO terminal, composite video input[USB]:USB terminal, USB input*: [COMPONENT] may be displayed as [RGB]depending on the settings of [Component/RGB-inselect]. (see page 46)Note● Displays the signal name as set in [Input label]. (seepage 50)● Input will not be switched unless [Input lock] is set to[Off]. (see page 65)● Image retention (image lag) may occur on the liquidcrystal panel when a still picture is kept on the panelfor an extended period. To prevent such a problem,using the screensaver and wobbling is recommended.(see page 49, 52)RECALLIt is possible to check the setting status of input label,picture mode, etc.Press .Current setting status will be displayed.1234567PC16:9Backup mode OKAUDIO1 INMemory name: MEMORY2Off timer 90 min1 Input label2 Aspect mode (see page 33)3 Backup input change (see page 62, 64)4 Audio input (see page 64)5 Profile name (see page 45)6 Off timer remaining time (see page 32)7 Clock / Mute (see page 32)● The followings are displayed for about 30 seconds atthe end: [No signal] - when there is no video signal tothe selected input, [No external media] - when a USBmemory is not connected to the USB terminal at thetime of using the USB input.● To display the clock, set [Date and time], and then set[Clock display] to [On]. (see page 54, 68)