|
English66PC auto settingSets the operational mode of the automatic positionadjustment in the [Position] menu.[Off]:Automatic position adjustment starts when SETUP> is pressed on the remote control orautomatic position adjustment is executed from the[Position] menu.[On]:Other than remote control or menu operation,automatic position adjustment starts:• When the display power is turned ON.• When the input signal is switched.Off-timer functionEnables / disables Off timer function.[Enable]:Enables the [Off-timer function].[Disable]:Disables the [Off-timer function].Note● When [Disable] is set, the Off-timer is cancelled.Initial startupSets the power mode of the unit for when the powerrecovers from failure or after plugging off and in again.[Last memory]:Power returns in as the same state as before thepower interruption.[On]:Power returns in power On.(Power Indicator: green)[Standby]:Power returns in standby mode.(Power Indicator: red/orange)Note● When using multiple displays, [Standby] is preferredto be set in order to reduce a power load.Startup logoSets to display / not to display the Panasonic logo on thescreen when the display is turned on.[Off]:Panasonic logo is not displayed.[On]:Panasonic logo is displayed.Display IDSets ID number when controlling the Display with[Controller ID function] and [Serial ID function].0 - 100 (Standard value: 0)Controller ID functionEnables/Disables the ID remote control function.To operate this function, please purchase ID remotecontroller sold separately. (see page 90)[Off]:Disables the ID remote control function. (Can beoperated as normal remote control.)[On]:Enables the ID remote control function.Effective on switching to [On].Note● To use the ID remote control function, setting IDnumbers both for the remote control and for thedisplay unit is required.For ID number setting for the remote controland display unit, see page 90 and [Display ID]respectively.Note● About how to reset the settings to defaults:“Initialization” (see page 69)Serial ID functionSet to control external control with the PC connected toSERIAL terminal according to the Display’s ID number(Panel ID).[Off]:Disables external control by the ID.[On]:Enables the external control by the ID.Serial response(ID all)Sets whether to respond to the command or not, whenserial command of ID No “0” is received.[Off]:Does not respond.[On]:Responds.
|
