Panasonic TH-55SF1HU Operating Instructions Manual

Also see for TH-42SF1HU: Operating instructions

Contents

Panasonic TH-55SF1HU Operating Instructions Manual Manual pdf 88 page image

English88■ USB memory contents checkYou can run a USB memory contents check in [USBmedia player settings] - [Scenario file check]. (see page57)If an error is present, the information is given with thefollowing details.A(B): CDA: Name of the file with an errorB: Row with an errorC: Error codeD: Detail of the errorNote● Shows leading error codes.Details of the detected errors are as follows.Errorcode Detail of the error1. No USB memory is inserted.2. scenario.dat/filelist.dat/lightid.dat cannotbe opened.3. There is an error in the contents ofscenario.dat/filelist.dat.4. The play file format is not supported.5. No play file exists.6. The necessary group ID for Multi MediaPlayer has not been specified.7. There are several identical file definitions.8. The scenario’s play time is over the limit.9. The file definition listed in the scenario isnot in the file list.10. The scenario contains 0 or over 1000 playfiles.11. There are 0 or over 1000 play files.(Single Media Player (Type 1) only)12. Only the group ID is listed on the file list.(Multi Media Player only)13. There is an error in the contents of lightid.dat.• For error code 1, 11 and 13, only the error codeand the detail of the error are displayed as shownbelow.1No USB memory is inserted.Supplementary noteThe USB memory contents check does not determinewhether or not a play file is playable.If a file cannot be played while Media Player is active,an error message will be displayed.When performing the synchronized playback on theMulti Media Player, check in the menu [USB mediaplayer settings] - [Scenario file check] that the file isplayable.Network environment (Multi MediaPlayer only)■ Example of setting up LAN connection andIP address / Subnet maskAs mentioned below, connect several units together withLAN cables and set up IP addresses / Subnet masks sothat all the displays exist on the same network.Parent IP address:Subnet mask:192.168.10.1255.255.255.0Child IP address:Subnet mask:192.168.10.2255.255.255.0Child IP address:Subnet mask:192.168.10.3255.255.255.0Child IP address:Subnet mask:192.168.10.4255.255.255.0Note● Set [Network control] of all displays to [On]. (see page54)● Depending on the network environment,synchronization may be largely lost.● Do not connect other devices to prevent networktraffic jam.● With a router put in between, you cannot set upconnection. Use them within the same subnet.● Do not use wireless LAN for connection sinceplayback may not be performed normally.