English966 Select [YES] with and press.Data copy to the USB memory starts.The data will be overwritten when any data exists originally.Are you OK to write the data?Data to USB MemoryYES NOThe following message is displayed after data copyhas finished.Data copy finished.7 After data copy has finished, removethe USB memory device from the USBterminal.Copying the USB memory data to thedisplay1 Insert the USB memory device withcopied data to the USB terminal ofthe display of data copy destination(same as the step 1 on page 95).After the [Select Copy Type] screen is displayed, goto the step 5.Note● If the USB memory containing the data for cloningis connected in power-on state, the [Select CopyType] message in step 5 is displayed.2 Display [Setup] menu pressing.3 Select [OSD language] with andpress for over 3 seconds.The following display appears.OptionsDisplay serial numberShippingUSB data cloningSoftware licenses4 Select [USB data cloning] withand press .5 Select [USB Memory → Display] withand press .Select Copy TypeDisplay → USB MemoryUSB Memory → Display6 Select [YES] with and press.Data copy to the display starts.Do you copy the data?Data from USB MemoryYES NOThe following message is displayed after data copyhas finished.Cloning finished.Please turn off the power.7 After data copy has finished, removethe USB memory device from the USBterminal.8 Press the button> to turn the power OFF, andturn the power ON again.The copied content is applied to the display.● If the is locked,please disconnect the AC cord plug from the walloutlet.● When USB memory is not removed in the step7, the message [Select Copy Type] is displayedwhen the display is turned on again.Note● If the data is copied with [POWER button lock] set to[On], this function operates after turning the poweroff, and the cannot beused to turn the power on. In this case, remove thepower plug, wait sufficient time, and then connect thepower plug again to turn the power on.● [POWER button lock] function is only forTH-55SF1HU, TH-49SF1HU and TH-42SF1HU.
