4.9 Resource ProgrammingSerial Interface (RS-232C) Parameters806System Programming 4-137Description Assigns the communication parameters for the Serial Interface (RS-232C) interface.New line code: Select the code for your printer or personal computer. If yourprinter or personal computer automatically feeds lines with acarriage return, select “CR”. If not, select “CR+LF”.Baud rate: A baud rate code indicates the data transmission speed from thesystem to the printer or personal computer.Word length: A word length code indicates how many bits compose a character.Parity: A parity code indicates what type of parity is used to detect an errorin the string of bits composing a character. Make an appropriateselection depending on the requirements of your printer or personalcomputer.Stop bit: A stop bit code indicates the end of a bit string which composes acharacter. Select an appropriate value depending on therequirements of your printer or personal computer.Selection • New line code: CR+LF / CR(CR=Carriage Return, LF=Line Feed)• Baud rate (baud): 150 / 300 / 600 / 1200 / 2400 / 4800 / 9600 / 19200• Word length (bits): 7 / 8• Parity bit: None / Mark / Space / Even / Odd• Stop bit length (bits): 1 / 2Default New line code = CR+LF; Baud rate = 9600; Word length = 8;Parity bit = Mark; Stop bit = 1Programming 1. Enter 806.Display: 806 RS232 PORT2. Press NEXT to program new line code.Display example: NL-Code:CR+LF3. Keep pressing SELECT until the desired selection isdisplayed.4. Press STORE.5. Press NEXT to program baud rate.Display example: Baud Rate:96006. Keep pressing SELECT until the desired selection isdisplayed.7. Press STORE.
