4.6 Outside Line ProgrammingCPC Signal Detection Outgoing Set4154-108 System ProgrammingDescription Enables or disables Calling Party Control (CPC) Signal Detectionduring the time between the originated outside call and theestablished outside call. If this is enabled, the system disconnectsthe line with the time set in program [405] “CPC Signal DetectionIncoming Set” when the CPC Signal is detected.Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)• Enable (detection) / Disable (no detection)Default DisableProgramming 1. Enter 415.Display: 415 CPC OUTGOING2. Press NEXT.Display: CO Line NO?→3. Enter an outside line number.To enter outside line number 1, you can also press NEXT.Display example: CO1:Disable4. Keep pressing SELECT until the desired selection isdisplayed.5. Press STORE.6. To program another outside line, press NEXT or PREV, orSELECT and the desired outside line number.7. Repeat steps 4 through 6.8. Press END.Conditions • Some central offices (CO) may send CPC-like signals during the dialingsequence and an attempt to make a call may be terminated. If your COis such a type, select “Disable”.• Program [405] “CPC Signal Detection Incoming Set” is used to setCPC Signal Detection Time.• To assign all outside lines to one selection, press the key in step 3. Inthis case, the display shows the contents programmed for outside line 1.Feature References Section 3, FeaturesCalling Party Control (CPC) Signal DetectionDirect Inward System Access (DISA)
