4.3 System ProgrammingCaller ID Code Set110System Programming 4-43Description Sets the identification code of the calling party (Caller ID Code) toutilize a Caller ID Service provided by a specific central office(CO). If an ID Code transmitted from the CO is found in the CallerID Code Table, the caller’s ID Code or name given to the code inprogram [111] “Caller ID Name Set” is displayed on the telephone.This allows the called party to recognize the caller.Selection • Location number: 001 through 100• Caller ID Code: 11 digits (max.)Default All locations – Not storedProgramming 1. Enter 110.Display: 110 CALLER ID #2. Press NEXT.Display: Location NO?→3. Enter a location number.To enter location number 001, you can also press NEXT.Display example: 001:Not Stored4. Enter a Caller ID Code.To delete the current entry, press CLEAR.To change the current entry, press CLEAR and enter the new code.5. Press STORE.6. To program another location, press NEXT or PREV, orSELECT and the desired location number.7. Repeat steps 4 through 6.8. Press END.Conditions • Each Caller ID Code has a maximum of 11 digits, consisting of 0through 9.• Program [111] “Caller ID Name Set” is used to give names to the CallerID Codes. If an ID Code is assigned a name, the called party’stelephone will show the name in place of the ID Code.• Program [406] “Caller ID Assignment” is used to enable the Caller IDService on an outside line basis.Feature References Section 3, FeaturesCaller ID
