4-6 System ProgrammingViewing the Display The display gives you helpful information, such as what you shoulddo now, what you have done, etc..The KX-T7433, KX-T7436, KX-T7230 and the KX-T7235 utilizetwo information lines for programming. The upper line is called theMessage Line and the lower one is called the Function Line.The Message Line (upper) shows you what you should do or whatyou should select. It also allows you to confirm what you have justentered. The display capacity is 16 digits. If your entry exceeds thecapacity, you can shift the display by pressing or button.The Function Line (lower) shows the current function of the softbuttons. These functions change with the programming procedures.SYS-PGM NO? →CLR NEXTKX-T7230 Display← Message Line← Function LineSYS-PGM NO? →CLR NEXTKX-T7433 Display← Message Line← Function LineSYS-PGM NO? →CLR NEXTKX-T7436 / KX-T7235 Display← Message Line← Function LinePress PROGRAM (or PAUSE) + + # and enter your SystemPassword (default=1234).Before entering the programming modeBefore entering programming mode, confirm that:• Your telephone is on-hook.• No calls are on hold at your telephone.Entering the programming mode• The display shows the Initial Message: SYS-PGM NO? →Note • If your telephone set does not have a PROGRAM button, substitute itwith the PAUSE button.• If nothing is entered in five seconds after the PROGRAM (or PAUSE)button is pressed, it is cancelled.• The System Password entered is not shown on the display. The SystemPassword can be changed by System Programming. Refer to Section4.3 [107] “System Password”.• During the programming mode, your extension is treated as a busyextension.• Only one proprietary telephone can be in programming mode at anyone time.4.1.1 Using Proprietary Telephones
