Destination AvailabilityDISAAnalog/ISDN Remote MaintenanceIdle Line Access no. + Phone no.Trunk Group Access no. + Trunk Group no. + Phone no.Extension of Another PBX (via TIE Line, Access with PBX Code)Extension of Another PBX (via TIE Line, Access without PBX Code)*1 A PS destination can be used to forward fax calls to a fax machine at another PBX connected by TIE line.A virtual PS can be specified as the destination of fax calls. Then, the extension number of the fax machine at the other PBX can bespecified as the FWD—ALL Calls destination for calls to that virtual PS. (® 19.1.2 Virtual PS)Conditions• Hardware Requirement:An OPB card and ESVM4 card• When using this feature, it is necessary to disable the MSG Feature setting of the IPCMPR card.• This feature is only effective for calls arriving on DISA lines.• If a fax signal is not detected before the DISA Intercept Routing—No Dial timer expires, the call is redirectedto the operator extension, and fax detection ends.• It is not recommended to use the CNG feature when an MSG card is installed in the PBX.Installation Manual References3.3.1 IPCMPR Card3.7.1 OPB3 Card (KX-NCP1190)3.7.6 ESVM4 Card (KX-TDA0194)PC Programming Manual References3.5 [1-1] Slot—OPB3 Card Property— MSG Feature7.4 [5-3-2] Voice Message—DISA Message— Fax ExtensionFeature Manual References4.1.8 DISA (Direct Inward System Access)1.1.7 Automatic Time AdjustmentDescriptionThe PBX clock can be adjusted automatically in the following two ways:1. Daylight Saving Time SettingThe start and end dates of Daylight Saving Time can be programmed. The PBX clock will automaticallyadjust itself one hour forward or backward at 2:00 A.M. on the programmed date, if enabled through systemprogramming. At 2:00 A.M. on the start date, the clock will change to 3:00 A.M., and at 2:00 A.M. on theend date, the clock will change to 1:00 A.M.24 Feature Manual Document Version 2009-121.1.7 Automatic Time Adjustment
