Operation Manual – Smart Link-Monitor LinkH3C S3100 Series Ethernet Switches Chapter 2 Monitor Link Configuration2-5Operation Command RemarksConfigure the specifiedlink aggregation group asa downlink port of theMonitor Link grouplink-aggregation groupgroup-id downlinkMonitorLink groupviewport interface-typeinterface-number downlinkquitinterface interface-typeinterface-numberConfigurea downlinkport fortheMonitorLink groupConfigurethespecifiedEthernetport as adownlinkport of theMonitorLink groupEthernetport viewport monitor-link groupgroup-id downlinkRequiredUse eitherapproachCaution:z A Smart Link/Monitor Link group with members cannot be deleted. A Smart Linkgroup as a Monitor Link group member cannot be deleted.z The Smart Link/Monitor Link function and the remote port mirroring function areincompatible with each other.z If a single port is specified as a Smart Link/Monitor Link group member, do not usethe lacp enable command on the port or add the port to another dynamic linkaggregation group because doing so will cause the port to become an aggregationgroup member.z Using the copy command on a port does not copy the Smart Link/Monitor Link groupmember information configured on the port to any other port.2.3 Displaying Monitor Link ConfigurationAfter the above-mentioned configuration, you can use the display command in anyview to display the information about Monitor Link, so as to verify configuration result.Table 2-5 Display Monitor Link configurationOperation Command RemarksDisplay the informationabout one or all MonitorLink groupsdisplay monitor-link group{ group-id | all }You can use the displaycommand in any view.
