Operation Manual – VLANH3C S3100 Series Ethernet Switches Chapter 2 VLAN Configuration2-10II. Configuration procedureFollow these steps to associate a port with the protocol-based VLAN:To do... Use the command... RemarksEnter system view system-view —Enter port view interface interface-typeinterface-number —Associate the port withthe specifiedprotocol-based VLANport hybrid protocol-vlanvlan vlan-id { protocol-index[ to protocol-index-end ] | all }RequiredBy default, a port is notassociated with anyprotocol-based VLAN.2.3.4 Displaying Protocol-Based VLAN ConfigurationTo do... Use the command... RemarksDisplay the information about theprotocol-based VLANdisplay vlan [ vlan-id [ to vlan-id ]| all | dynamic | static]Display the protocol informationand protocol indexes configuredon the specified VLANdisplay protocol-vlan vlan{ vlan-id [ to vlan-id ] | all }Display the protocol informationand protocol indexes configuredon the specified portdisplay protocol-vlan interface{ interface-type interface-number[ to interface-typeinterface-number ] | all }Available inany view2.3.5 Protocol-Based VLAN Configuration ExampleI. Network requirementsz As shown in Figure 2-2, Workroom connects to the LAN through port Ethernet1/0/10 on the S3100 switch.z IP network and AppleTalk network workstations (hosts) coexist in the Workroom.z The S3100 switch connects to VLAN 100 (using IP network) through Ethernet1/0/11 and to VLAN 200 (using AppleTalk network) through Ethernet 1/0/12.z Configure the switch to automatically assign the IP and AppleTalk packets toproper VLANs for transmission, so as to ensure the normal communicationbetween the workstations and servers.
