Operation Manual – Link AggregationH3C S3100 Series Ethernet Switches Chapter 1 Link Aggregation Configuration1-10Table 1-3 Configure a dynamic LACP aggregation groupOperation Command RemarksEnter system view system-view —Configure the systemprioritylacp system-prioritysystem-priorityOptionalBy default, the systempriority is 32,768.Enter Ethernet port view interface interface-typeinterface-number —Enable LACP on the port lacp enableRequiredBy default, LACP isdisabled on a port.Configure the port priority lacp port-priorityport-priorityOptionalBy default, the port priorityis 32,768.Note:Changing the system priority may affect the priority relationship between theaggregation peers, and thus affect the selected/unselected status of member ports inthe dynamic aggregation group.1.4.4 Configuring a Description for an Aggregation GroupPerform the following tasks to configure a description for an aggregation group.Table 1-4 Configure a description for an aggregation groupOperation Command RemarksEnter system view system-view —Configure a descriptionfor an aggregation grouplink-aggregation groupagg-id descriptionagg-nameOptionalBy default, no descriptionis configured for anaggregation group.