Operation Manual – VLANH3C S3100 Series Ethernet Switches Chapter 2 VLAN Configuration2-4To do… Use the command… RemarksEnter VLAN view vlan vlan-idRequiredIf the specified VLAN does not exist,this command be created firstcreates the VLAN before entering itsview.Add an Access portto the current VLAN port interface-listRequiredBy default, system will add all portsto VLAN 1.Follow these steps to configure the Access-port-based VLAN in Ethernet port view:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure the port linktype as Access port link-type accessOptionalThe link type of a port isAccess by default.Add the current Accessport to a specified VLAN port access vlan vlan-idOptionalBy default, all Accessports belong to VLAN 1.Note:To add an Access port to a VLAN, make sure the VLAN already exists.2.2.2 Configuring a Hybrid-Port-Based VLANA Hybrid port may belong to multiple VLANs, and this configuration can only beperformed in Ethernet port view.Follow these steps to configure the Hybrid-port-based VLAN:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure the port linktype as Hybrid port link-type hybrid Required
