Operation Manual – MulticastH3C S3100 Series Ethernet Switches Chapter 2 IGMP Snooping Configuration2-13Operation Command RemarksConfigure specifiedport(s) as static memberport(s) of a multicastgroup in the VLANmulticast static-groupgroup-address interfaceinterface-listRequiredBy default, no port isconfigured as a staticmulticast group memberport.2.2.9 Configuring a Static Router PortIn a network where the topology is unlikely to change, you can configure a port on theswitch as a static router port, so that the switch has a static connection to a multicastrouter and receives IGMP messages from that router.I. In Ethernet port viewTable 2-14 Configure a static router port in Ethernet port viewOperation Command RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure the current portas a static router portmulticaststatic-router-port vlanvlan-idRequiredBy default, no static routerport is configured.II. In VLAN viewTable 2-15 Configure a static router port in VLAN viewOperation Command RemarksEnter system view system-view —Enter VLAN view vlan vlan-id —Configure a specified portas a static router portmulticaststatic-router-portinterface-typeinterface-numberRequiredBy default, no static routerport is configured.2.2.10 Configuring a Port as a Simulated Group MemberGenerally, hosts running IGMP respond to the IGMP query messages of the multicastswitch. If hosts fail to respond for some reason, the multicast switch may consider that
