Operation Manual – IPv6 ManagementH3C S3100 Series Ethernet Switches Chapter 2 IPv6 Application Configuration2-4I. Configuration prerequisitesEnable Telnet on the Telnet server and configure the authentication method. For details,refer to Login.Table 2-4 Set up IPv6 Telnet connectionsTo do… Use the command… RemarksPerform the telnetcommand on the Telnetclient to log in to otherdevicestelnet ipv6 remote-system [ -iinterface-type interface-number ][ port-number ]RequiredAvailable in userviewCaution:When you use the telnet ipv6 command to connect to the Telnet server, you mustspecify the “–i” keyword if the destination address is a link-local address.II. Display and maintain IPv6 TelnetTable 2-5 Display and maintain IPv6 TelnetTo do… Use the command… RemarksDisplay the useinformation of the userswho have logged indisplay users [ all ] Available in any view2.3 IPv6 Application Configuration Example2.3.1 IPv6 ApplicationsI. Network requirementsIn Figure 2-3, SWA, SWB, and SWC are three switches, among which SWA is an H3CS3100 Ethernet switch, SWB and SWC are two switches supporting IPv6 forwarding. Ina LAN, there is a Telnet server and a TFTP server for providing Telnet service andTFTP service to the switch respectively. It is required that you telnet to the telnet serverfrom SWA and download files from the TFTP server.
