Operation Manual – QoS-QoS ProfileH3C S3100 Series Ethernet Switches Chapter 1 QoS Configuration1-26[Sysname] traffic-limit vlan 2 inbound ip-group 2000 128 exceed remark-dscp561.4.5 Configuring Traffic ShapingNote:Only H3C S3100-EI series switches support this configuration.Refer to section Traffic Policing and Traffic Shaping for information about trafficshaping.I. Configuration prerequisitesz The maximum traffic rate and the burst size are determined.z The port where traffic shaping is to be configured is determined.II. Configuration procedureTable 1-22 Configure traffic shapingOperation Command DescriptionEnter system view system-view —Enter Ethernet portviewinterface interface-typeinterface-number —Configure trafficshapingtraffic-shape queuequeue-id max-rateburst-sizeRequiredTraffic shaping is not enabledby default.III. Configuration examples# Perform traffic shaping for all the traffic to be transmitted through Ethernet 1/0/1, withthe maximum traffic rate being 640 kbps and the burst size being 16 KB. system-view[Sysname] interface Ethernet1/0/1[Sysname-Ethernet1/0/1] traffic-shape 640 161.4.6 Configuring Port Rate LimitingRefer to section Port Rate Limiting for information about port rate limiting. Note that, thetarget-rate argument is committed information rate (CIR).
