Operation Manual – PoE-PoE ProfileH3C S3100 Series Ethernet Switches Chapter 1 PoE Configuration1-8Table 1-10 Display PoE configurationOperation Command DescriptionDisplay the PoE status of aspecific port or all ports of theswitchdisplay poe interface[ interface-typeinterface-number ]Display the PoE powerinformation of a specific port orall ports of the switchdisplay poe interface power[ interface-typeinterface-number ]Display the PSE parameters display poe powersupplyDisplay the status(enabled/disabled) of the PoEover-temperature protectionfeature on the switchdisplay poetemperature-protectionAvailable inany view1.3 PoE Configuration Example1.3.1 PoE Configuration ExampleI. Networking requirementsSwitch A is an S3100 series Ethernet switch supporting PoE, Switch B can be PoEpowered.z The Ethernet 1/0/1 and Ethernet 1/0/2 ports of Switch A are connected to Switch Band an AP respectively; the Ethernet 1/0/8 port is intended to be connected withan important AP.z The PSE processing software of Switch A is first upgraded online. The remotelyaccessed PDs are powered by Switch A.z The power consumption of the accessed AP is 2,500 mW, and the maximumpower consumption of Switch B is 12,000 mW.z It is required to guarantee the power feeding to the PDs connected to the Ethernet1/0/8 port even when Switch A is under full load.
