Operation Manual – System Maintenance and DebuggingH3C S3100 Series Ethernet SwitchesChapter 1 Boot ROM and Host SoftwareLoading1-12Enter your choice(0-3):Enter 2 in the above menu to download the host software using FTP.The subsequent steps are the same as those for loading the Boot ROM, except for thatthe system gives the prompt for host software loading instead of Boot ROM loading.Caution:When loading the Boot ROM and host software using FTP through BOOT menu, youare recommended to use the PC directly connected to the device as FTP server topromote upgrading reliability.1.3 Remote Boot ROM and Software LoadingIf your terminal is not directly connected to the switch, you can telnet to the switch, anduse FTP or TFTP to load the Boot ROM and host software remotely.1.3.1 Remote Loading Using FTPI. Loading Procedure Using FTP Client1) Loading the Boot ROMAs shown in Figure 1-8, a PC is used as both the configuration device and the FTPserver. You can telnet to the switch, and then execute the FTP commands to downloadthe Boot ROM program switch.btm from the remote FTP server (whose IP address is10.1.1.1) to the switch.Figure 1-8 Remote loading using FTP ClientStep 1: Download the program to the switch using FTP commands. ftp 10.1.1.1Trying ...Press CTRL+K to abortConnected.220 WFTPD 2.0 service (by Texas Imperial Software) ready for new userUser(none):abc331 Give me your password, please
