Paper Does Not Feed Properly/"No Paper" Error OccursCheck1 Make sure that paper is loaded.Loading PaperCheck2 Make sure of the following when you load paper.• When loading two or more sheets of paper, flip through the paper before loading. In addition, when you loadpaper with some paper remaining in the cassette, flip through the remaining paper and the newly loadedpaper before loading.• When loading two or more sheets of paper, align the edges of the sheets before loading.• When loading two or more sheets of paper, make sure that the paper stack does not exceed the paper loadlimit.However, proper feeding of paper may not be possible at this maximum capacity depending on the type ofpaper or environmental conditions (either very high or low temperature and humidity). In such cases, reducethe sheets of paper you load at a time to less than half of the paper load limit.• Always load the paper in portrait orientation, regardless of the printing orientation.Loading PaperImportant• When loading paper in the cassette, slide the paper guide on the front side to align with thecorresponding mark of page size. Load the paper with the print side facing DOWN, load the paperstack in the center of the cassette, then slide the paper guides to align with the both edges of the paperstack.Loading PaperCheck3 Check to see if the paper you are printing on is not too thick or curled.Media Types You Cannot UseCheck4 Make sure of the following when you load Hagakis or envelopes.• If a Hagaki is curled, it may not feed properly even though the paper stack does not exceed the paper loadlimit.Load Hagakis with a zip code column toward the far end of the cassette 1.• When printing on envelopes, refer to Loading Paper, and prepare the envelopes before printing.728
