Displaying the Preview ScreenWhen is displayed on the Copy standby screen, tapping allows you to preview an image of theprintout on the preview screen.Important• The preview screen is not available when you load the original in the ADF.• In the following conditions, is not displayed when the Copy standby screen is displayed.• 2-sided is selected for 2-sidedPrintSetting.• 2-on-1 copy or 4-on-1 copy is selected for Layout.• ON is selected for Collate.When either of the conditions above is selected, you can set to display the preview screen afterscanning the original is finished.When 2-sided, 2-on-1 copy, or 4-on-1 copy is selected and the original is loaded on the platenglass, you can set to display the preview screen after scanning the original is finished.Two-Sided CopyingCopying Two Pages to Fit onto a Single PageCopying Four Pages to Fit onto a Single PageCollated Copying• The original will be scanned to display the preview image. Therefore, do not open the document coveruntil the preview screen is displayed.• Originals are rescanned after displaying the preview screen and before copying starts. Therefore, donot open the document cover or remove the original from the platen glass while Scanning document...is displayed.A. A frame showing the selected page size appears over the image. The inside of the frame will be printed.B. The original that is set on the platen glass is displayed. Tap to select Fit to page. If the displayed imageis skewed, refer to Loading Originals and reset the original properly, then display the preview screenagain and preview the original.C. The magnification setting, which was set when the preview screen was displayed, is displayed. If thesetting other than Fit to page is selected, you can change the magnification setting by dragging the baron the touch screen.435
