Note• Tapping Details displays the security setting.The password required when connecting from the external device is also displayed.• You can specify the access point name (SSID) and the security setting optionally.Setting of the Access Point Mode7. Tap OK.The access point mode is enabled and the machine can be used as an access point.Printing/Scanning with the Access Point ModePrint/Scan with the access point mode following the procedure below.1. Connect an external device such as a computer or a smartphone to the machine viawireless LAN.Perform wireless LAN settings with your external device, then assign the access point name specifiedfor the machine as a destination.Note• For details on how to perform wireless LAN settings with an external device, refer to thedevice's instruction manual.• When a WPA2-PSK (AES) password is valid on the machine, entering the password is requiredto connect an external device to the machine via wireless LAN. Enter the password specified forthe machine.2. Start printing or scanning from an external device such as a computer or a smartphone.Note• For details on how to print or scan from an external device such as a computer or a smartphonevia wireless LAN, refer to the device's or application's instruction manual.How to terminate the Access Point ModeIn environments that the machine is connected with the computer over the wireless LAN usually, set themachine to the wireless LAN connection following the procedure below when you finish using the machinewith the access point mode temporarily.1. Flick the HOME screen, then tap Setup.Using the Operation Panel2. Tap Device settings.275
