Chapter 44-19F-4-894) Press the push switch (SW2) on the ADF controller PCB once.- A single press on the push switch (SW2) causes the original to be pickedup and sopped on the copyboard glass.F-4-905) Open the DADF slowly, and check to make sure that C shown is as indi-cated.T-4-6F-4-91Close the DADF, and press the push switch (SW2) on the ADF controllerPCB once.- The original will be delivered to the delivery tray.If the Value Is Not As IndicatedIf the value is not as indicated, adjust the position of the manual feed tray.1) Loosen the manual feed tray fixing screw, and adjust the position of themanual feed tray.F-4-92If C>3.1 mm, shift the original tray toward the rear.If C<3.1 mm, shift the original tray toward the front.2) At the end of adjustment, tighten the manual feed tray fixing screw.3) Set the DIP switch (SW1) on the ADF controller PCB back to its initialsetting, and mount the ADF controller cover.4.3.1.6 Original Stop Position Adjustment 0011-3479Original stop position adjustment is made for the following two:[1] Pickup from the original tray[2] Pickup from the manual feed tray ADF controller covera. Original Tray Pickup1) Remove the screw [1], and detach the ADF controller cover [2].F-4-932) Set the DIP switch (SW1) on the ADF controller PCB as indicated.F-4-943) Place a single sheet [1] of A4 or LTR copy paper in the original tray.F-4-954) Press the push switch (SW2) on the ADF controller PCB once.- A single press on the push switch (SW2) causes the original to be pickedup and stopped on the copyboard glass.F-4-965) Open the DADF slowly, and check to make sure that D indicated is 11±1Value of C3.1±1mmButted.Manual feed tray Copy paperJ1J2J5J3 J6 J7 J8 J9 J10J16 J15J11J14IC8J13J12J4 CB1SW1DSP1SW4SW3SW2COriginalScrewManual feed tray[1][2]J1J2J5J3 J6 J7 J8 J9 J10J16 J15J11J14IC8J13J12J4 CB1SW1DSP1SW4SW3SW2
