Chapter 33-19F-3-1303) When you have removed the ADF controller cover, disconnect the con-nector [3] of the ADF controller PCB; then, remove the screw [4], and re-move the grounding wire [5]. Free the harness from the wire saddle [6],and detach the other saddle [7].F-3-1314) Remove the four screws [1], and detach the main cover [2].The main cover is fitted with the original tray [3], and cables are connectedto it. Take extra care when removing it not to damage the cables.F-3-1323.4.5.4 Removing the Delivery Roller 0011-24871) Remove the screw [1] from the bottom of the DADF, and remove the bear-ing [2] and the rod [3].F-3-1332) Remove the four screws [1], and detach the hinge (right) [2].F-3-1343) Remove the E-ring [1], and detach the solenoid link arm [2].F-3-1354) Remove the screw [1], and detach the delivery guide plate [2].5) Remove the screw [3], and free the grounding wire [4] of the staticeliminator attached to the delivery guide.F-3-1366) Remove the three screws [1], and disconnect the connector [2]; then, de-tach the solenoid unit [3] from the delivery assembly front side plate.[2]HooksPush. Freed.[5][7][4][6][3][1] [1][1][1][3][2][2] [3] [1][1][1][1] [2][1][1][1] [2][1] [2][4] [3]
