Chapter 33-12F-3-803.4.1.3 Removing the Registration Roller 0011-36081) Remove the two screws [1], and detach the reversing guide [2].When mounting the reversing guide, do so while forcing it in the directionof the arrow. If not mounted properly, it can trigger jams.F-3-812) Remove the two screws [1], and detach the registration sensor PCB [2].F-3-82When removing the registration sensor PCB, be sure to disconnect the con-nector of the cable connected to it.F-3-833) Remove the grip ring [1] and the bearing [2] of the registration roller [3](front side plate).F-3-844) Remove the E-ring [1], gear [2], E-ring [3], and bearing [4] of the regis-tration roller [5] (rear side plate).The gear holds a pin. Take care not to lose it when removing the gear.F-3-853.4.2 Reversing Roller3.4.2.1 Removing the Front Cover 0011-82081) Remove the front cover [1].-Three screws [2] (remove)-One screw [3] (loosen)F-3-86[1] [1][1][1][3][2][1][1] [2]Only when mounting it.[1][1] [2]Registration sensor PCB Connector[1][3] [2][2] [1] [3] [4] [5]
