Chapter 44-17F-4-724) Press the push switch (SW2) on the ADF controller PCB twice.- A single press on the push switch (SW2) causes the original to be pickedup and stopped on the copyboard glass. (CW rotation) Another press willreverse the original and stop it on the copyboard glass.F-4-735) Open the DADF slowly, and check to make sure that A and B indicated inthe figure are 2 mm or less. Close the DADF, and press the push switch(SW2) on the ADF controller PCB once.- The original will be delivered to the delivery tray.F-4-74F-4-75If the Value Is Not As IndicatedIf the value is not as indicated, adjust the position of the registration roller.1) Remove the front cover [1].-Three screws [2] (remove)-One screw [3] (loosen)F-4-76F-4-77F-4-782) Loosen the fixing screw on the reversal registration roller mounting plate,and slide it to the left and the right to adjust the mounting angle of the reg-istration roller.F-4-79If A>0, slide the mounting plate to the left.If B>0, slide the mounting plate to the right.3) At the end of adjustment, tighten the fixing screw on the reversal registra-tion roller mounting plate.4) Set the DIP switch (SW1) on the ADF controller PCB back to its initialsetting, and mount the ADF controller cover.4.3.1.5 Horizontal Registration Adjustment 0011-3454Horizontal registration adjustment is made for the following two:[1] Pickup from the original tray[2] Pick up from the manual feed traya. Pickup from the Original Tray1) Remove the screw [1], and detach the ADF controller cover [2].J1J2J5J3 J6 J7 J8 J9 J10J16 J15J11J14IC8J13J12J4 CB1SW1DSP1SW4SW3SW2ABOriginalA 2mmB 2mmJ1J2J5J3 J6 J7 J8 J9 J10J16 J15J11J14IC8J13J12J4 CB1SW1DSP1SW4SW3SW2ScrewReversal registration rollermounting plate
