Chapter 33-25F-3-1724) Remove the four screws [1], and detach the main cover [2].The main cover is fitted with the original tray [3], and cables are connectedto it. Take extra care when removing it not to damage the cables.F-3-1733.4.8.3 Removing the Feeding (pull-off) Roller 0011-36071) Remove the mounting screw [2] of the gear support plate [1] of the pickupfront side plate.F-3-1742) Remove the E-ring [1], washer [2], two shims [3], gear (black) [4], gear(white) [5], two shims [6], and spring [7] in sequence.F-3-1753) Remove the gear support plate of the front side plate.4) Remove the E-ring [2], gear [3], parallel pin [4], grip ring [5], and bear-ing [6] of the feeding (pull-off) roller [1] (front side plate).F-3-1765) Remove the E-ring [2], gear [3], parallel pin [4], E-ring [5], and bearing[6] of the feeding (pull-off) roller [1] (rear side plate); then, remove thefeeding (pull-off) roller [1].The gear holds a pin. Take care not to drop it.F-3-1773.4.9 Document Tray3.4.9.1 Removing the Original Tray 0011-25631) Remove the ADF controller cover.3) Disconnect the connector [1] of the ADF controller PCB; then, remove thescrew [2], and remove the grounding wire [3].4) Free the harness from the wire saddle [4],5) Detach the other saddle [5].Push. Freed.[5][7][4][6][3][1] [1][1][1][3][2][1][2][1][5][6][4][3][3][2][2][3][1][5][6] [4][6] [5] [4] [1] [2][3]
